ADJUSTMENT GP-HYDRAULIC TRACK 2367889 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A         Loctite 271     1    Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g01097895
Install nut (10) to lever (4) .
Apply Tooling (A) to the threads of lever (4) prior to installation.
Install lever (4) to pilot control valve (7) . Lever (4) must be installed for a minimum of four turns.
Hold lever (4) in the orientation as shown and tighten nut (10) to a torque of 70 5 N m (51 4 lb ft).
Install grommet (11) . Pull the wiring harness through the hole in pilot control valve (7) .
Install electrical connector (9) . For instructions on servicing Deutsch connectors refer to Special Instruction, SEHS9615.
Illustration 2 g01097520
Install pilot control valve (7) and lever (4) .
Install four screws (6) .
Install the six fittings and connect six hose assemblies (8) to pilot control valve (7) .
Connect electrical connector (9) and install cover (5) .
Illustration 3 g01097519
Install covers (1) , (2) and (3) .
Fill the hydraulic tank with oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".End By:
Install the seat. Refer to Disassembly and Assembly, "Seat - Remove and Install".
Remove the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Remove and Install".