AFTERCOOLER AS-AIR 3351446 - Caterpillar

3351446 AFTERCOOLER AS-AIR Caterpillar parts 120K, 120K 2, 12K, 140K, 140K 2, 160K

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3351446
335-1446
3351446

Weight: 43 pounds 19 kg.

Buy AFTERCOOLER AS-AIR 3351446 Caterpillar genuine, new aftermarket tractor parts with delivery
MOTOR GRADER,

Compatible equipment models: 3351446:

MOTOR GRADER 120K 120K 2 12K 140K 140K 2 160K Caterpillar

Number on catalog scheme: 2

Caterpillar 3351446 Parts scheme AFTERCOOLER AS-AIR

For full view, you need register

Information:

Illustration 3 g01250265
Engine compartment (left side)
(2) Ether injection solenoid
Thoroughly inspect ECM connectors (1) and the connectors for solenoid (2). Also inspect the circuit from the ECM connector to the ether injection solenoid. Refer to Troubleshooting, "Electrical Connectors - Inspect" for details.
Illustration 4 g01250273
Terminal locations at the P1 ECM connector for the ether injection solenoid
(P1-10) Ether injection solenoid
(P1-18) Digital return
Illustration 5 g01218763
Terminal locations at the harness connector for the ether injection solenoid
(Terminal 1) Ether injection solenoid
(Terminal 2) Solenoid return
Perform a 45 N (10 lb) pull test on each of the wires in the ECM connector that are associated with the circuit.
Check the torque of the allen head screws for the ECM connectors. Refer to Troubleshooting, "Electrical Connectors - Inspect" for the correct torque values.
Check the harness and the wiring for abrasion and for pinch points from the ether injection solenoid to the ECM. Expected Result:All connectors, pins, and sockets are completely coupled and/or inserted. The harness and wiring are free of corrosion, of abrasion, and of pinch points.Results:
OK - The connectors and the wiring appear to be OK. Proceed to Test Step 2.
Not OK - There is a problem in the connectors and/or wiring.Repair: Repair the connectors or wiring and/or replace the connectors or wiring. Ensure that all of the seals are properly in place and ensure that the connectors are completely coupled. Verify that the repair eliminates the problem.STOPTest Step 2. Check for Active Diagnostic CodesNote: The ether canister must be removed prior to activating this test.
Turn the battery disconnect switch to the ON position.
Connect Caterpillar Electronic Technician (ET) to the service tool connector.
Turn the keyswitch to the ON position.
Proceed to the "Diagnostic Overrides" screen on Cat ET.
Activate the ether injection system. The diagnostic override will activate for ten seconds.
Monitor the active diagnostic code screen on Cat ET. Check and record any active diagnostic codes. Note: Wait at