AIR CONDITIONER GP 1188583 - Caterpillar

These towing instructions are for moving a disabled machine a short distance, at a low speed, not faster than 2 km/h (1.2 mph); to a convenient location for repair or transport. These instructions are for emergencies only. Always transport the machine if a long distance move is required.Shielding must be provided on the towing machine, to protect the personnel in area.Do not allow an operator on the machine being towed, unless the operator can control the steering and/or braking.Before towing, make sure the tow line or bar is in good condition and has enough strength for the towing situation involved. Use a towing line or bar with a strength of at least 1.5 times the gross weight of the towing machine for towing a disabled machine stuck in mud or when towing on a grade.When towing, attach the tow line only to the down holes.Do not use a chain for pulling. A chain link can break causing possible personal injury. Use a wire rope cable with loop or ring ends. Use an observer in a harmless position to stop the pulling procedure if the cable starts to break or unravel. Stop pulling whenever the pulling machine moves without moving the towed machine.Keep the tow line angle to a minimum. Do not exceed a 30° angle from the straight ahead position.Sudden machine movement could overload the tow line or bar and cause it to break. Gradual and smooth machine movement will work better.Normally, the towing machine should be as large as the disabled machine. Satisfy yourself that the towing machine has enough brake capacity, weight and power, to control both machines for the grade and distance involved.To provide sufficient control and braking when moving a disabled machine downhill, a larger towing machine or additional machines connected to the rear could be required. This will prevent it from rolling uncontrolled.All different towing situation requirements cannot be given; since, minimal towing machine capacity is required on smooth level surfaces and maximum towing machine capacity is required on inclines or poor surface conditions.Consult your Caterpillar dealer for towing a disabled machine. Engine Running
Turning on a slope will reduce the stability of the machine and could result in tip over accident.
If the power train and the steering system are operable, and the engine is running, the machine can be towed a SHORT DISTANCE or can be pulled out of the mud.The operator on the towed machine MUST steer in the direction of the tow line.Make certain that all instructions outlined in this topic, Towing Information, are carefully and exactly followed. Engine StoppedTo move the machine when the engine is not operable, a provision has been made to attach a brake release pump.Consult your Caterpillar dealer for the equipment necessary for towing a disabled machine.The pressure hose from the pump connects to the brake valve. The pump takes oil from the sump of the brake release pump and pressurizes the brake valve to release the brake. 1. Block the drums securely at locations (1)