AIR CLEANER ASSEMBLY 13420088 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 389-5758 Support 2 Start By:
Install the steering frame lock. Refer to Operation and Maintenance Manual, "Steering Frame Lock".
Personal injury or death can result from improper lifting or blocking.When a hoist or jack is used to lift any part or component, stand clear of the area. Be sure the hoist or jack has the correct capacity to lift a component. Install blocks or stands before performance of any work under a heavy component.Approximate weights of the components are shown. Clean all surfaces where parts are to be installed.
Personal injury or death can result from machine articulation or movement.Machine frames can move and a person can be crushed.Connect the steering frame lock link between the front and rear frames before working on machine.
At operating temperature, the hydraulic tank is hot and under pressure.Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Put identification marks on all lines, hoses, wires, and tubes for installation purposes. Plug all lines, hoses, and tubes. Plugs help prevent fluid loss and contamination of the oil system.
Chock the wheels of the machine in order to prevent any movement of the machine during the maintenance procedure.
Raise the truck body. Secure the truck body in the RAISED position with tooling (A).
Disengage the parking brake. Refer to Operation and Maintenance Manual, "Parking Brake Manual Release".
Illustration 1 g00771550
Loosen retaining nut (1) in order to disconnect hose (2) from actuator (3). Remove bolt (4), washer (5) and clip (6) that secures hose (7) to parking brake (8).
Illustration 2 g00771553
Remove cotter pin (9) and pin (10) in order to release shoe retainer (11).
Illustration 3 g00771554
Remove two brake shoes (12), two springs (13) and two spacers (14).
Illustration 4 g00771555
Attach a suitable nylon lifting sling around parking brake (8), around actuator (3) and to a suitable hoist. Remove four bolts (15) and four washers (16). Carefully remove parking brake (8) from the machine and be sure not to catch on any wires or loose hoses. The weight of parking brake (8) is 45 kg (100 lb).