AIR CONDITIONER GP 1907375 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Removal Procedure
Start By:
Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: The naturally aspirated 3054 marine engine has one piston cooling jet that is located inside the number one cylinder. The naturally aspirated 3056 marine engine is not equipped with piston cooling jets.
Illustration 1 g00548374
Illustration 2 g00606467
Remove valve assembly (1) from piston cooling jet (2).
Remove piston cooling jet (2) from the cylinder block. Note: The engine crankshaft may be rotated in order to access all of the piston cooling jets.Note: Ensure that the ball moves freely within the valve assembly of the piston cooling jet. Check that the tube of the piston cooling jet is not damaged.
Remove hollow dowel (3) from the cylinder block. Note: Hollow dowel (3) is used to locate the piston cooling jet.
Repeat Steps 1 through 3 for the removal of the remaining piston cooling jets. Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g00548374
Illustration 4 g00606467
Install piston cooling jet (2) to the cylinder block. Note: Ensure that piston cooling jet (2) is properly located on hollow dowel (3). Refer to the Specifications Manual, "Piston Cooling Jet" for the correct procedure for the alignment of the piston cooling jet.
Install valve assembly (1) into the piston cooling jet (2). Tighten the banjo bolt of the valve assembly (1) to a torque of 20 N m (15 lb ft).
Repeat Steps 1 through 2 for the installation of the remaining piston cooling jets. End By:
Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".