AIR CLEANER GP 3244149 - Caterpillar

Illustration 20 g03422736
Right-hand side battery box (K) 239.40 mm (9.425 inch) (L) 281.40 mm (11.079 inch) (M) 449.00 mm (17.677 inch) (N) 10 mm (0.40 inch) diameter holes for mounting bracket (18)
Lay out and drill two 10 mm (0.40 inch) diameter holes (N) in the right-hand side battery box. Remove any burrs.Use weld nuts, or washers and nuts, on the inside of the battery box for bolts (5) and washers (3) .
Illustration 21 g03423508
Step assembly removed earlier
Disassemble steps from removed bracket (R5) .
Illustration 22 g03423517
Reassembled step assembly on the right-hand battery box (16) 436-9199 Bracket As (18) 437-3688 Bracket As
Reassemble steps on newly installed brackets on the right side battery box as shown in Illustration 22.
Illustration 23 g03423789
Installing the platform assembly (inset shows the underside of the platform assembly) (2) 7X-0632 Hard Washer (5) 8T-4136 Bolt (15) 436-9195 Rear Platform As
Use bolts (5) and washers (2) to install platform assembly (15). Do not tighten the bolts at this time.
Illustration 24 g03423790
Installing the platform assembly (inset shows the underside of the platform assembly) (2) 7X-0632 Hard Washer (4) 8T-4133 Nut (5) 8T-4136 Bolt (8) 8T-4196 Bolt (14) 434-0653 Platform As (15) 436-9195 Rear Platform As
Use the listed hardware in Illustration 24 to install platform assembly (14) to the platform and step assemblies. Do not tighten the bolts at this time.Use three bolts (5) and washers (2) to secure the platform to the platform. Use four bolts (8), eight washers (2), and four nuts (4) to secure the platform to the lower step bracket.
Ensure fit up of both platform and platform, then tighten all the bolts and nuts installed in Step 11 and Step 12.
Illustration 25 g03423791
List of parts for platform assembly (3) 7X-7729 Washer (4) 8T-4133 Nut (7) 8T-4195 Bolt (12) 124-2456 Film ("NO STEP") (14) 434-0653 Platform As (15) 436-9195 Rear Platform As (17) 437-3661 Bracket
Platform assembly (14) is pre-drilled for the rear egress assembly available for the left side of the machine. The parts listed in Illustration 25 are to be installed as needed by the customer. These parts will require drilling holes for installing brackets (17) to meet the customer needs. Hardware is included in the kit to mount the bracket where the customer wants.Note: Platform assembly (14) is not to be assembled as a stairway on the right-hand side of the machine.
Illustration 26 g03423793
"NO STEP" film (12) 124-2456 Film ("NO STEP")
Apply two films (12) onto the right-hand platform assembly as necessary.Note: Do not install brackets (17) where the view of films (12) are obstructed.
Illustration 27 g03429332
Maximum designed weight load for platform and bracket (PW) 91 kg (200 lb) maximum design platform weight (BW) 136 kg (300 lb) maximum design bracket weight
The platform has been developed with maximum loads under typical applications. Refer to Illustration 9 for maximum design loads and the location of these loads.