AIR CONDITIONER AR 3727531 - Caterpillar

Illustration 1 g01451159
Select "Wireless Communication Support".
Illustration 2 g01319860
Select "Yes" in order to enable the wireless communication.When "Yes" is selected, the radio will need to be configured for "EZ IP" or "IP". Use MCG Flash in order to configure the radio.The IP address must match the radio for the Office. The Radio network will be disabled.Wireless Communication Option
AccuGrade Wireless Communication is an available option for the AccuGrade CD700 Display. This option provides the site manager the ability to transmit updated design information to the machines on site, perform basic remote diagnostics and send simple test messages to the machines over the wireless network. This option can be purchased and installed on each CD700 Display.Option Key Purchase Procedure
Refer to the appropriate AccuGrade pricelist to order the AccuGrade CD700 Wireless Communication Option Key.
Order the key per the instructions on the pricelist.
Record the following information:
wireless key reference number
order dealer code
order reference number
Obtain and record the serial number from identification plate on display to have wireless communications option activated.
Go to the website: "www.techproductregistration.com".Refer to Special Instruction, REHS3666, "Software Activation for the AccuGrade® Display" for additional information.Within 30 minutes an e-mail will be sent to the dealer email address submitted on the web form. This e-mail will have the option key number in order to activate the option on the requested display. A phone call will be made to phone number submitted on web form to confirm e-mail with option key number was received. Provide this key to the appropriate person to have installed on display. Save this option key information for future reference. An invoice will be sent from Antares for the purchase of the option key.Procedure For Entering The Registration Key Into The Display
Power the system up in Service Mode by turning machine key to the "ON" position.
Press and hold the "OK" Key while pressing the Power Key.
Press the Menu Key.
Illustration 3 g01455855
Press the "Installation" Soft Key.
Use the Arrow Keys (14) in order to select "Software Support Option".
Press the "OK" key (16) .
Perform one of the two options below:
Copy the Wireless Option key file to the root directory of a data card. Insert the Data Card. The Display will read the key.
Enter the 24 character option key that was obtained above. To do this, use the Arrow Keys on the Display. Press the "OK" Key.If the procedure is successful, the "Option Keys File Loaded" dialog appears. This indicates that one option key has been loaded successfully.
Press the "OK" Key.The Plan View appears.Note: If key does not activate, verify that key was entered correctly. Verify that the serial number on identification plate is the same as electronic serial number.