AIR CLEANER GP 3755006 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-0520     Driver Group     1    Start By:
Remove the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01125301
Remove bolts (4) and retaining plate (1) .
Remove camshaft idler gear (2) .
Remove bolt (7) and idler shaft (3) from the cylinder block. Remove thrust plate (5) .
Use Tooling (A) and a suitable press to remove bearing (6) from camshaft idler gear (2) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-0520     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01125304
Use Tooling (A) and a suitable press to install bearing (6) in camshaft idler gear (2). Install the bearing until the bearing is 1.080 0.250 mm (0.0425 0.0098 inch) below the front face of camshaft idler gear (2) .
Position thrust plate (5) and idler shaft (3) on the cylinder block. Install bolt (7). Tighten the bolt to a torque of 70 15 N m (51 11 lb ft).
Install camshaft idler gear (2) on idler shaft (3). Ensure that timing mark (8) is facing outward. Align timing mark (8) with timing mark (9) on crankshaft drive gear (10) .
Position plate (1) and install bolts (4). Tighten the bolts to a torque of 70 15 N m (51 11 lb ft).End By: Install the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Install".