AIR BLOW GUN 4C3302 - Caterpillar

Illustrations 35 and 36 show parameters for TRUCKS ONLY and should NOT be installed for loader machines. If installed, the payload system will not communicate data to VisionLink properly.Security System Tamper Resistant Configuration
Illustration 37 g06203306This parameter is used to install the tamper feature on the machine. The tamper feature allows for remote disable of machines from VisionLink. This feature is available on Product Link Elite systems, but is not yet compatible with the MWL Advanced Machine Security System Installation Status feature that is available on the transmission ECM. Do not install both Tamper and Advanced Machine Security System on the same MWL.VIMS Main Module
Passwords
Illustration 38 g03367691
Customer set passwords, to be selected and set for customer.
General information
Illustration 39 g03367693
Information to be filled in after activation
Internet Protocol
Illustration 40 g03367694Fuel management standard
Illustration 41 g03367696PLM installation parameters
Illustration 42 g03367700Graphical Display
Machine Identification
Illustration 43 g06203315
Displays service mode code set at factory along with language and units status
Monitoring System Parameters
Illustration 44 g06203327Camera System
Illustration 45 g06203331Object Detection
Illustration 46 g06203333Engine #1 Aftertreatment Controller
ECM Identification Parameters
Illustration 47 g06203345Aftertreatment Configuration
Illustration 48 g06203347