AIR CLEANER GP 4P9221 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
1 3898898 FILM-TORQUE
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 40% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
The 389-8898 Torque Film which specifies the correct torque for each terminal and warns against using an impact wrench needs to be installed on the accessory power converter. Refer to the attached Rework Procedure.
OWNER NOTIFICATION
U.S. and Canadian owners will receive the attached Owner Notification.
SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
100% 100% 0% 0% 0% 0%
This is a 0.5-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
COPY OF OWNER NOTIFICATION FOR U.S. AND CANADIAN OWNERS
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING A TORQUE FILM ON THE ACCESSORY POWER CONVERTER ON CERTAIN D7E TRACK-TYPE TRACTORS
MODELS INVOLVED - D7E
Dear Caterpillar Product Owner:
The 389-8898 Torque Film needs to be installed on the products listed below to help prevent unintended damage to the accessory power converter during service. The use of an impact wrench or over tightening the battery terminals on the accessory power converter can result in the battery being unable to charge properly. This film calls out the proper torques for the terminals and warns against the use of an impact wrench. You will not be charged for the service performed.
Contact your local Caterpillar dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
Please refer the dealer to their Service Letter dated 24Jan2012 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Caterpillar Inc.
Identification #(s)
Attached to 24Jan2012 Service Letter
Rework Procedure
The accessory power converter is located behind the right side fender enclosures.
1. Open the two right side enclosures to access the accessory power converter. Refer to Image 1.1.1.
Image1.1.1
2. Thoroughly clean the surface of the accessory power converter where the 389-8898 Torque Film will be placed. A parts cleaner or equivalent may be used to provide a clean surface for the film to adhere. Refer to Image 1.2.1.
Image1.2.1
3. Install the film in the location as shown in Image 1.2.1.
Note: Install the film with the "30 +/- 7Nm" torque at the top. Refer to Image 1.3.1.
Image1.3.1