ALARM AS 1545428 - Caterpillar

Illustration 1 g03345790
Table 1
Specification for 355-8842 Electric Starting Motor Gp
Item Qty Part Specification Description
1 - - Torque to 8.75 1.05 N m (77.44 9.29 lb in).
2 1 045-4065 Screw Torque to 2.6 0.8 N m (23.0 7.1 lb in).
3 1 045-4065 Screw The switch terminal must be insulated with heat shrink tubing. Do not use molded terminals.
Torque to 2.6 0.8 N m (23.0 7.1 lb in).
4 1 6V-8188 Nut Ground terminal.
Final Installation torque is 30.5 3.5 N m (269.9 30.9 lb in).
5 1 6V-8188 Nut Motor frame terminal.
Final Installation torque is 30.5 3.5 N m (269.9 30.9 lb in).
6 1 - Start relay terminal (High side).
Final Installation torque is 2.25 0.25 N m (19.91 2.21 lb in).
7 1 - Start relay terminal ground (Low side).
Final Installation torque is 2.25 0.25 N m (19.91 2.21 lb in).
8 1 6V-8188 Nut Motor terminal.
Final Installation torque is 30.5 3.5 N m (269.9 30.9 lb in).
9 1 6V-8188 Nut Battery terminal.
A maximum of three cable terminals or wire terminals may be used between the battery terminal nuts. A maximum of two of the cable terminals may be equal to or greater than 0 AWG.
Final Installation torque is 30.5 3.5 N m (269.9 30.9 lb in).
B - - Clearance between the pinion and the housing is 9.1 mm (0.36 inch).
- - - Operating temperature range is −25° to 121 °C (−45° to 217 °F).
- - - Operating voltage is 24 VDC.
- - - Pull-in current at 20 V and 25 °C (77 °F) is 49.3 3.3 Amp.
- - - Hold-in current at 20 V and 25 °C (77 °F) is 6.8 Amp max.
- - - When the electric starting motor is viewed from the pinion end, the motor rotates in the clockwise direction.
- - - No load performance at 25 °C (77 °F):
Speed is 6612 1887.5 rpm.
Current draw is 100 30 Amp.
Voltage is 23 VDC.