ALTERNATOR 0819379 - Caterpillar

Illustration 1 g06339064
Typical example
Table 1
Item Qty Part Specification Description
- All bores must be free of paint. Use the 5P-0960 Grease Cartridge in order to lubricate the bores for the pins.
1 2 489-3008 Sleeve Bearing Before assembly, inside diameter is 90.21 0.04 mm (3.552 0.002 inch).
Installation depth is 13.6 0.3 mm (0.54 0.01 inch).
2 6 166-1495 Lip Type Seal Lubricate the sealing lip of the lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces the outside, as shown. Install the lip type seals so that the lip of the type seals does not extend beyond the face of the boss.
3 2 451-2184 Nut Torque to 325 40 N m (240 30 lb ft).
Position the nut (3) to the distance 0.0 to 0.5 mm (0.00 to 0.02 inch) past the end of the bolt. For locking, tighten the nut (2) against the nut (3).
4 2 451-2184 Nut
5 - - During linkage group assembly on the machine, rotate the rod end of the bucket cylinder in order to position the grease fitting away from stick.
6 1 517-2509 cpn Diameter is 89.850 0.025 mm (3.5374 0.0010 inch).
7 1 517-2508 cpn Diameter is 69.850 0.025 mm (2.7500 0.0010 inch).
8 2 234-3931 Pin As Diameter is 89.850 0.025 mm (3.5374 0.0010 inch).