ALTERNATOR 0831296 - Caterpillar

Illustration 1 g00683171
The cab and the ROPS can be tilted to the rear of the machine in order to permit easy access to the engine and hydraulic components.
Illustration 2 g00683175
Remove nuts and washers (1) under the cab.
Illustration 3 g00683180
Illustration 4 g00683204
Remove bolts (5) . Remove bolts (6) . Remove the muffler. Remove the exhaust pipe (7) .
Remove the ROPS mounting bolts (2) , nuts and washers.
Illustration 5 g00683217
Install bolts (6) in holes (8) .
Illustration 6 g00683221
Use pump (9) in order to raise the ROPS. Use pump (9) in order to raise the cab.
Align hole (3) with the holes in bracket (4) on each side of the machine. Install bolts (5) through holes (3) .
Work can now be performed on the engine and other components in the engine compartment.Lower The Cab and The ROPS
Use pump (9) in order to relieve the pressure from bolts (5) .
Remove bolts (5) .
Lower the cab and lower the ROPS in position with pump (9) .
Remove bolts (6) .
Install the ROPS bolts. Tighten the ROPS bolts to a torque of 800 N m (590 lb ft).
Install bolts (5) . Install bolts (6) .
Install exhaust pipe (7) . Install the muffler.
Install the two nuts (1) in the mounts in the front of the cab.