ALTERNATOR A 0859408 - Caterpillar

Parking Brake Holding Ability Test
Note: If the machine configuration changes, the parking brakes need to be tested.Check the area around the machine. Make sure that the machine is clear of personnel and clear of obstacles.Fasten the seat belt before checking the parking brake.The following tests are used to determine if the parking brake is functional on a specified grade or a specified slope. These tests are not intended to measure the maximum brake holding effort. Read all of the steps before you perform the following procedure.
Illustration 1 g03045676Position the machine on the incline of the slope, but near the base of the slope in order to check the parking brake. The test position should be 26 percent or a 15 degree slope.
Start the engine. Refer to the Operation and Maintenance Manual, "Engine Starting" for information on starting the engine.
Move the machine into the test position.
Engage the parking brake. The machine should not move under the following conditions.
The engine is at low idle.
The parking brake is applied.
The machine is positioned on the specified slope.
Personal injury can result if the machine moves while testing.If the machine begins to move, release the parking brake and use the propel lever in order to move the machine to a level surface.
Park the machine on a level surface.
Stop the engine.
If the machine moved during the brake test, consult your Caterpillar dealer.The dealer must inspect the brake system and make any necessary repairs before the machine is returned to operation.