ALTERNATOR GP 10R8919 - Caterpillar

Dozer Blade Tilt (If Equipped)
1. Pull the tilt lever toward you to lower the left side of the blade.2. Push the tilt lever away from you to lower the right side of the blade. 3. If additional tilt is required, the left brace may be adjusted (if equipped). Shorten the brace to make left side of blade lower. Lengthen the brace to make the left side of blade higher.If the tilt brace length needs alteration, turn the handle to the left (counterclockwise), to lengthen it. Turn the handle to the right (clockwise), to shorten the brace.Dozer Blade Tip (If Equipped)
Lengthen the left brace and extend the right cylinder to tip the blade forward. Shorten the left brace and retract the right cylinder to tip the blade back.Dozer Blade Angling
The blade can be positioned to various angles with the following instructions.1. Remove the lock pin from the retainer pin. (One on each side).2. Remove the coupling retainer pins.3. Pull the coupling pin out of the housing.4. Position the blade at the desired angle.5. Install the coupling pins in the new positions.6. Install the coupling retainer pins.7. Install the lock pins.Ripper Tips
Replace ripper tips before wear occurs on the shank. Follow the procedures in the "Maintenance Section" for replacement.Tracks
If tracks are too tight or loose, wear of components is accelerated. If they appear too tight or too loose, adjust the track. Follow the procedures in the "Maintenance Section" for adjustment.
Cutting Edges and End Bits
Replace or reverse the cutting edges or end bits, before wear occurs on the blade base. Follow the procedures in the "Maintenance Section" for replacement.Brake Pedal Position
The brake pedal can be installed on the shaft in a HIGH or LOW position. The pedal is usually installed in the LOW position except for tractors to be delivered in Japan.The brake pedal can easily be changed from one position to the other and without affecting the linkage adjustments. The above illustration shows the HIGH and LOW positions. Each dimension is measured from the bottom edge of the pedal to the floor plate. The pedal is in the HIGH position when the timing mark on the end of the pedal shaft is in alignment with the center of the slot in the pedal. The pedal is in the LOW position when the bottom of the pedal is rotated down one spline from the timing mark.Winching
The winch has an adjustable sequence valve, which permits the selection of either "no inch" or "inching" characteristics, during reel out operations.Inching is the controlled movement of the cable during a reel out operation. The "inching" setting is generally used when the machine and winch are used for construction and pipeline work. This setting gives the operator the control necessary to put an object in an exact position.Where precise control is not necessary, as when logs are moved, the "no inch" setting may be used.When using the inching setting, move the winch control lever to the reel out channel. Move the lever into the channel to