ALTERNATOR GP-CHARGING (24V-70 AMP) 1450616 - Caterpillar

Start By:
Remove the transmission crankcase guard.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Park the machine on a hard, level surface. Engage the parking brake. Install Tooling (C) to prevent the machine from moving.
Install the steering frame lock. Refer to Operation and Maintenance Manual, "Steering Frame Lock".
Illustration 1 g06266280
Typical example
Illustration 2 g06301836
Typical example
Position Tooling (B) to support the front frame as shown. Refer to Tool Operating Manual, NEHS1303 , "Lift Group (Stand - 25 Ton)" for more information on Tooling (B).
Illustration 3 g01201631
Illustration 4 g01327804
Typical example
Position Tooling (A) under stabilizer rod (5). Use suitable chains to secure Tooling (A) to stabilizer rod (5). The weight of stabilizer rod (5) is approximately 50 kg (110 lb).
Remove bolts (4) and bolts (6) that secure stabilizer rod (5) to frame (2).
Remove stabilizer rod (5) from the machine.
Note the orientation of the mounting brackets on spherical bearings (1) and (3) in relationship to stabilizer rod (5) for installation purposes. Use a suitable press to remove the spherical bearings from the stabilizer rod.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 1U-7505 Hydraulic Jack 1
D 504-9791 Lift Gp(1) 2
OR
504-9793 Lift Gp(2) 2
C 425-0952 Chock 2
(1) High Voltage (480V) Low Voltage (240V)
(2) High Voltage (400V) Low Voltage (200V)
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 5 g01327804
Typical example
Illustration 6 g01201631
Use a suitable press to install spherical bearings (1) and (3) into stabilizer rod (5). The bolt holes in the mounting brackets on the spherical bearings must parallel the center line of the stabilizer rod.
Use Tooling (A) to position stabilizer rod (5). The weight of stabilizer rod (5) is approximately 50 kg (110 lb).
Install bolts (4) and (6) that connect stabilizer rod (5) to frame (2).Note: The distance between frame (2) and the mounting bracket may be too tight. Place suitable jack stands under the frame of the truck bed. Raise the frame to increase the distance between the frame and the mounting bracket.
Illustration 7 g06266280
Typical example
Illustration 8 g06301836
Typical example
Remove Tooling (B).
Remove Tooling (C).End By:
Install the transmission crankcase guard.