ALTERNATOR GP-CHARGING 1571670 - Caterpillar

Illustration 4 g03128398
(4) 267-5001 Plate As (5) 8T-4909 Bolt and 8T-4224 Hard Washer (6) 351-8490 Communication Electronic Control Module (7) 382-9554 Control Harness As
Fix the 267-5001 Plate As (4) on the four 5C-9855 Bosses ((M8 × 1.25)) (3) by using 8T-4909 Bolt and 8T-4224 Hard Washer (5) .
Illustration 5 g03130196
(8) Location of 351-8490 Communication Electronic Control Module inside the cab
Install the 351-8490 Communication Electronic Control Module (6) on the 267-5001 Plate As (4) by using 8C-5607 Isolation Mount , 8C-5606 Base As , 8C-8451 Bolt , and 9X-6165 Washer .
Connect the 382-9554 Control Harness As (7) to the cab harness.
Illustration 6 g03128417
(9) 375-1382 Cable As (10) Cab harness (11) 289-3038 Grommet
Route the 375-1382 Cable As (9) from the 351-8490 Communication Electronic Control Module (6) .
Illustration 7 g03130256
(12) 37 mm (1.45 inch) diameter hole
Drill a new side 37 mm (1.45 inch) diameter hole (12) on the 247-6535 Plate to add the 289-3038 Grommet (11). Refer to the Illustration 6 and the Illustration 7.
Illustration 8 g03130396
(13) 7T-1099 Link
Route the 375-1382 Cable As (9) through the five 7T-1099 Links (13) fixed on the bottom of the cab.
Tie and secure the 375-1382 Cable As (9) by using 3S-2093 Cable Strap .
Illustration 9 g03130397
(14) 348-6864 Hood As
Install the 346-9376 Antenna As on the 348-6864 Hood As (14) .
Illustration 10 g03130398
(15) 19 mm (0.75 inch) hole
Drill a 19 mm (0.75 inch) hole (15) in the 348-6864 Hood As (14) .
Install the 346-9376 Antenna As in the hole (15) .
Tie and secure the 346-9376 Antenna As on the 348-6864 Hood As (14) with best practices.
Illustration 11 g03130417
(16) 4P-7581 Clip
Connect the 375-1382 Cable As (9) and 346-9376 Antenna As by using the 4P-7581 Clip (16) .