ALTERNATOR GP-CHARGING 1860186 - Caterpillar

At operating temperature, the engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot water or steam. Any contact can cause severe burns. Look at the sight gauge to check the coolant level. The coolant level should be in the green range. If necessary, remove the fill cap only after the engine has been stopped and the cap is cool enough to remove with your bare hand. Remove the cooling system fill cap slowly to relieve pressure. Cooling system condition contains alkali that can cause personal injury. Avoid contact with the skin and eyes and do not drink. Allow cooling system components to cool before draining.
At operating temperature, the hydraulic oil tank is hot and under pressure. Hot oil can cause burns. Remove the breather filter cap only when the engine is stopped and the breather filter cap is cool enough to touch. Slowly loosen the breather filter cap to release any pressure in the hydraulic tank. Be cautious of hot hydraulic oil when any lines are disconnected in the hydraulic system.
Put identification on all lines, hoses, wires and tubes for installation purposes. Cap and plug all lines, hoses and tubes to prevent foreign material from entering the system. Drain all fluids in a suitable container for storage or disposal. 1. Drain the oil from the power train oil system in a suitable container for storage ore disposal.2. Disconnect two hose assembly (1) from the torque divider.3. Disconnect wire harness (2) from torque divider outlet relief valve (3).4. Disconnect hose assembly (4) from torque divider outlet relief valve (3).5. Disconnect hose assembly (5) from the implement pump. 6. Disconnect hose assembly (6) from the torque divider.7. Disconnect hose assembly (7) and remove hose clip (8). 8. Disconnect two hydraulic hose assemblies (9) from the pressure control valve.9. Disconnect two hydraulic hose assemblies (10) from the pressure control valve.10. Disconnect hydraulic hose assembly (11) from the pressure control valve. 11. Disconnect two hydraulic hose assemblies (12) from the implement pump.12. Disconnect hydraulic hose assembly (13) from the implement pump. 13. Disconnect wire harness (14).14. Disconnect two wire terminals (15) and remove all necessary tie straps. 15. Remove four bolts (16) and remove plate assembly (17) from both sides of the cab platform. 16. Remove ether start aid line (18).17. Disconnect fuel hose assembly (20) from the priming pump.18. Remove five fuel hose clips (19) from the engine. 19. Disconnect wires (21) and (22) from the starter. Repeat for the starter on the other side. 20. Remove exhaust cover assembly (23) and (24).21. Remove exhaust elbow (25). 22. Disconnect fuel hose assembly (26). 23. Disconnect hose assembly (28) from the air conditioner compressor.24. Remove hose clip (27). 25. Disconnect hydraulic hose assemblies (29) and (30) from the hydraulic oil cooler. 26. Remove hose assembly (31) from the water pump.27. Disconnect two heater hose assembly (32) from the water pump. 28. Fasten a hoist and Tool (A) as shown. Tool (B) is