ALTERNATOR GP-CHARGING 1896556 - Caterpillar

Table 1
Required Parts List
Item Qty Part Number Part Name
1 2 096-4883 Locknut
2 2 8T-4121 Hard Washer
3 1 114-1399 Gauge Pipe
4 1 122-8705 U-Bolt
5 1 8T-4192 Bolt
6 1 8T-4223 Hard Washer
7 1 544-6993 (1) Support
1 420-5026 (2) Support
(1) For 336 and 340 models
(2) For 329 and 330 models
Illustration 1 g06242990
Swing drive group
Refer to the following rework procedure to add the new support for field machines :Rework Procedure
Illustration 2 g06243014
(A) Clip
(B) 30 mm (1.2 inch)
(C) Current location
(D) New location
Relocate the clip (A) by dimension (B) lower from current location as shown in Illustration 2.Note: This Step is required only for 336 and 340 models.
Install the support (7) by using bolt (5) and hard washer (6) to the swing drive group. Refer to Illustration 1.Note: Apply thread locker to the threads of bolt (5).Note: For 336 and 340 models, use 544-6993 Support.Note: For 329 and 330 models, use 420-5026 Support.
Install the gauge pipe (3) to the swing drive group. Refer to Illustration 1.Note: While installing the gauge pipe (3), apply and spread sealant continuously on all around of three threads width. Alternate sealant three bond TB1110F.
Install the U-bolt (4) by using two locknuts (1) and two hard washers (2) to the support (7) through the gauge pipe (3). Tighten the two locknuts (1) to a torque of 22 3 N m (195 27 lb in). Refer to Illustration 1.