ALTERNATOR GP-CHARGING 2058587 - Caterpillar

2058587 ALTERNATOR GP-CHARGING Caterpillar parts D9T

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2058587
205-8587
2058587

Caterpillar 2058587 ALTERNATOR GP-CHARGING

Buy ALTERNATOR GP-CHARGING 2058587 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

This part in 1 request: Show. This information for suppliers only!

#136529 2058587 2018-01-19

Compatible equipment models: 2058587:

TRACK-TYPE TRACTOR D9T Caterpillar

Number on catalog scheme:

Caterpillar 2058587 Parts scheme ALTERNATOR GP-CHARGING

For full view, you need register

Information:

Removal Procedure
Start By:
Remove the water pump. Refer to Disassembly and Assembly, "Water Pump- Remove" for the correct procedure.
Remove the crankshaft pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove" for the correct procedure.
If the engine is equipped with a fan, remove the fan. Refer to Disassembly and Assembly, "Fan - Remove and Install" for the correct procedure.
Remove the crankshaft front seal from the front cover. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Remove and Install" for the correct procedure.
Illustration 1 g03410400
Remove bolts (3), bolts (4), and bolts (5). Identify the positions of bolts of different length.
Remove front cover (1) from the front housing.
Remove gasket (2). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Studs
M8 by 70 mm 2
B 364-7210 Front Cover Alignment Tool 1
Illustration 2 g03410407
Illustration 3 g03410401
Ensure that all components are clean and free from damage. Replace any damaged components.
Thoroughly clean the gasket surface of the front housing.
Thoroughly clean front cover (1).
Install Tooling (A) into Holes (X) in the front housing.
Install a new gasket (2) onto Tooling (A).
Install front cover (1) onto Tooling (A).
Install bolts (3), bolts (4), and bolts (5) finger tight. Ensure that the bolts of different length are installed in the correct positions.
Use Tooling (B) to align the front cover assembly.
Remove Tooling (A) and install remaining bolt (3) and bolt (4).
Tighten bolts (3), bolts (4), and bolts (5) to a torque of 22 N m (195 lb in).
Remove Tooling (B).
Install a new crankshaft front seal to the front cover. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Remove and Install" for the correct procedure. End By:
Install the water pump. Refer to Disassembly and Assembly, "Water Pump- Install" for the correct procedure.
Install the crankshaft pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Install" for the correct procedure.
If the engine was equipped with a fan, install the fan. Refer to Disassembly and Assembly, "Fan - Remove and Install" for the correct procedure.