ALTERNATOR GP-CHARGING 2060353 - Caterpillar

Operator Console
Illustration 2 g06229168
Right side of operator console
(24) Operator console power button
(25) Horn button
(26) Operator console commanded stop switch
(27) Not used this machine series
(28) Machine work light button
(29) RFID chip slotOperator Console Power Off / Commanded Stop switch (26), when pressed, will discontinue the RC session.When the Operator Console Power Off / Commanded Stop switch (26) is pressed, the following occurs:
Commanded Stop is sent to the machine immediatelyNote: For the recommended Operator console shutdown procedure see the Operation Section, "Return to Manual Operation" chapter of this manual.
Implements will remain in position when the machine shuts down. Approach the machine with caution
Normal Power Down Procedure
Ensure the Machine Power / Engine Crank switch is in the OFF position.
Press the Operator Console Power button (24) to turn off the Operator Console power.When finished operating in remote control, refer to the Operation and Maintenance Manual, M0085769, "Return to Manual Operation" section for Operator Console to return the machine to manual operation. By using the proper procedure all (key-on) machine power will be cut and the remote control session will be terminated. To recover the remote control session return to the Operation and Maintenance Manual, M0085769, "Before Operation" section for Operator Console and follow the startup procedure for the Operator Console system.Software Stop (Complete/Immediate Shutdown)
The following situations will automatically disengage the remote control system and place the machine in a Complete/Immediate shutdown. In this state, the system immediately shuts down the engine, engages the parking brake, engages the implement lockout, and cuts power to the machine. To recover the remote control session return to the Operation and Maintenance Manual, M0085769, "Before Operation" section for Operator Console and follow the startup procedure for the Operator Console system.
Implements will remain in position when the machine shuts down. Approach the machine with caution.
Commanded Stop
Pressing the Operator Console Power Off / Commanded Stop switch on the Operator Console (Immediate stop)
Switching the Manual/Remote Mode switch, on the Ground Level Service Center, into manual mode. (Remote control system is powered down, Manual operation is restored)
The Manual Override switch in the machine cab is placed in override (manual) position
The Operator Console is tilted beyond 45 degrees (Immediate stop)Note: A sensor that is located inside the operator console monitors the level of the Operator Console. When the Operator Console is tilted beyond 45 degrees or dropped, the sensor triggers a Commanded Stop.Software Stop (Safe Stop State)
The following situations will automatically disengage the remote control system and place the machine in a safe stopped state. In this state, the service brake is ramped to full, the parking brake is engaged, and the implement lockout is engaged prior to deactivating remote control. The engine speed is reduced to low idle and not shutdown in these cases:
Receiver stops communicating with the operator console. (With a loss of connection, the machine will continue to operate for 1 second with the last known good command, then come to an immediate stop
The wireless range, between the console and the receiver, is exceeded. (Refer to the Operation and Maintenance