ALTERNATOR GP-CHARGING 2319143 - Caterpillar

Removal Procedure
Illustration 1 g00739085
Remove the cover from the front of the console. Remove screws (1).
Illustration 2 g00739101
Remove screws (2) from the rear of the console.
Illustration 3 g00739106
Open armrest (3). Remove screws (4) and armrest (3).
Illustration 4 g00739111
Reposition cover (6) in order to access harness assemblies (5) on the right hand console. Disconnect harness assemblies (5).
Remove cover (6) from the console.
Illustration 5 g00739116
Disconnect harness assemblies (7) from the joystick.
Illustration 6 g00739127
Lift rubber boot (8) over handle (9). Note: Mark the location of locknut (10) and the handle for installation procedures.
Hold nut (11). Loosen locknut (10). Unscrew handle (9) in order to remove the handle.
Remove rubber boot (8) from the handle. Installation Procedure
Illustration 7 g00739127
Install rubber boot (8) on the handle.
Install handle (9) in nut (11) to the original position. Hold nut (11). Tighten locknut (10) to a torque of 49 3 N m (36 2 lb ft).
Illustration 8 g00739116
Connect harness assemblies (7) to the joystick.
Illustration 9 g00739111
Place cover (6) over the joystick, as shown.
Connect harness assemblies (5).
Illustration 10 g00739106
Install armrest (3) and screws (4).
Illustration 11 g00739101
Install screws (2) to the rear of the console.
Illustration 12 g00739085
Install screws (1) and the cover.