ALTERNATOR ASSEMBLY 2N6396 - Caterpillar

Illustration 1 g00854866
Note: The wire insulation should be in accordance with applicable local codes.Note: Both contacts for low oil pressure at low speed and low oil pressure at high speed can be wired in parallel in order to control a single oil pump.
Table 1
System    Relay    Normally Open    Normally Closed    Common    
Oil     OPLARX1     454A     454B     454C    
Oil     OPLARX2     453A     453B     453C    
Fuel     FPLARX     440A     440B     440C    
Jacket Water     JWPARX     441A     441B     441C    
Aftercooler / Oil Cooler     AWPLARX     442A     442B     442C    
Sea water     SWPLARX     443A     443B     443C     The manual start push button can be used to manually start the standby pump for the given system. Push the stop button in order to stop a standby pump that is running. When the lamp that indicates normal conditions is on, the pump will remain off. However, if the lamp that indicates normal conditions is off the standby pump will restart when you release the stop button.The lamp that indicates a normal condition will be illuminated, whenever the pressure in the monitored system is normal.Whenever the standby pump is running, the lamp that indicates that the standby pump is running will illuminate. The standby pump can be operated by the set of contacts for auto start in the standby pump panel, or the push button for manual start. The push button that is used for manual starting is found on the control panel for the standby pump.
Table 2
Lamp that indicates that the standby pump is running    Lamp that is indicating normal conditions    Indication    
On     Off     The standby pump is running. The standby pump was initiated by the standby pump panel.    
On     On     The standby pump is running. The standby pump was initiated manually.    
Off     On     Normal    
Off     Off     There is an abnormal indication. Troubleshoot lamps, wiring, and circuit operation.    Note: An extra set of normally open contacts from each