ALTERNATOR GP-CHARGING 3669145 - Caterpillar

1. Remove the cotter pin and pin (2) from the plate. Remove pedal (1) and the spring from the plate. 2. Remove three screws (4) and two bolts (3). Remove plate (5). 3. Pull throttle valve (6) up and put identification on the air lines.4. Disconnect the air lines from unions (7).5. Remove the throttle valve.Install Throttle Valve
1. Install pedal (1), spring (3) and pin (2) on the plate. Install the cotter pin that holds pin (2) in place. 2. Connect the two air lines to unions (4) and in their original position. 3. Put plate (5) in position on the throttle valve and install the three screws that hold it in place. 4. Put the plate in position on the floor plate and install bolts (6).Disassemble Throttle Valve
start by:a) remove throttle valve 1. Remove screws (2) and plate (1) from the valve. 2. Remove screw (3) and the nut from plunger (6).3. Remove boot (5) and ring (4) from the plunger. Remove the plunger from the plate.Assemble Throttle Valve
1. Put plunger (3) through plate (5) as shown and install ring (2) on the plunger.2. Install boot (4) on the plunger.3. Install screw and nut (1) in the plunger. 4. Put the plate in position on the valve and install screws (6).end by:a) install throttle valveRemove And Install Torque Stop
The fuel injection pump housing and governor does not have to be removed to remove or install the torque stop.
TYPICAL EXAMPLE1. Remove torque stop housing (1).
TYPICAL EXAMPLE 2. Remove torque control (2). Disassemble the torque control by removing two insulators (3), bar (4), contact (5) and shim (6). 3. Remove load pin (7).4. Install the load pin.5. Assemble the torque control by installation of the two insulators, the contact and the shim to the bar.6. Install the torque control.7. Install the torque stop housing.end by: a) make adjustment of the fuel system setting (See Fuel System Setting in Testing and Adjusting)