ALTERNATOR GP-CHARGING 3830134 - Caterpillar

Illustration 38 g03685948
Pass cable assembly (60) down from the upper compartment of the electric service center to the lower compartment of the electric service center. Secure the 9W-3460 Battery Terminal As of cable (60) to the exposed positive(+) post (C) of the new batteries (52) .
Illustration 39 g03685949
Plug drain wire of cable assembly (60) into resistor (64). Using two straps (27) secure resistor assembly (64) to cable assembly (60). Using three straps (27) secure the drain wire to cable assembly (60) and to the clip (39) attached to the battery hold down rod.
Illustration 40 g03688004
Illustration 41 g03686115
Pass the cable assembly (65) down from the upper compartment of the electric service center to the lower battery compartment of the electric service center. Install one grommet (67) after cable in passed through hole. Secure the 352-4705 Battery Terminal As of cable assembly (65) to the exposed negative post (D) of the new batteries. Using one bolt (16), one washer (12), and one clip (66) secure the drain wire and the cable assembly (65) to the boss (E). Secure the drain wire of cable assembly (60) to the cable assembly (65) with one strap (27) .
Illustration 42 g03686219
In the upper battery compartment attach the 311-2835 Battery Terminal As , of cable assembly (60), to the exposed positive(+) terminal of the batteries. Pass remaining end of cable assembly (60), up through top of the upper battery compartment.
Illustration 43 g03686531
Install grommet (68) onto cable assembly (60). Secure cable assembly (60) at locations (G ) and (F), using two bolts (16), two washers (12), and two clips (69). Secure cable assembly (60) at location (H) using one bolt (16), one washer (12), one spacer (67), and one clip (62) .
Illustration 44 g03686532
Illustration 45 g03686533
Attach cable assembly (65) and 365-8810 Receptacle As (T) to the "Negative" battery post. Reinstall the 3E-6754 Grommet (U) around 365-8810 Receptacle As (T) and the drain wire. Secure drain wire and 365-8810 Receptacle As together using two straps (27) at location (J) .
Illustration 46 g03688052
Illustration 47 g03686555
In upper electrical compartment, attach cable assembly (65) and drain wire (V) to the switch (K). Secure the drain wire to 365-8810 Receptacle As at locations (L) using three straps (27) .
Illustration 48 g03686552
Secure cable assembly (60) to the junction block. Secure drain wire (N) to cable assembly (60) using strap (27). Connect the drain wire (N) connector at location (M) .
Illustration 49 g03688261
Install panel (70) and reinstall the ladder assembly (N), handrail (P) plate (R), and cover (S) .