ALTERNATOR GP-AXLE 4763209 - Caterpillar

Illustration 57 g02265137
Double click the "Event Input Function #N Suspect Parameter Number (SPN)" setpoint to change this value from the drop-down menu. Click the "OK" button to program.
Illustration 58 g02265153
Double click the "Event Input Function #N Failure Mode Identifier (FMI)" set point to change this value from the drop-down menu. Click the "OK" button to program.
Illustration 59 g02265154
Configure the "Active State Configuration" setpoint according to your wiring. Select either active "High" or active "Low". Click the "OK" button to program.
Once the input is set with an SPN and FMI, check the "Event Response Configuration". Not all SPN and FMI combinations are valid. Table 3 indicates which FMIs are valid for which SPNs. If a combination other than one indicated with a "Y" in the table above is configured, the event will not trigger any response by the OCP. The OCP may not give the option of an invalid FMI for a given SPN. In Cat ET, there is no restriction on the SPN/FMI combination. An invalid combination in Cat ET will result in an "Out of Range" error.
Table 3
Failure Mode Identifier Valid Options
Category Suspect Parameter Number High Shutdown Low Shutdown High Warning Low Warning Status
Pressures Engine Oil Pressure Y Y Y Y Y(1)
Gas Pressure Y Y Y Y
Temperatures Engine Coolant Temperature Y Y Y Y
Engine Oil Temperature Y Y Y Y
Exhaust Temperature Y Y Y Y
Levels Engine Coolant Level Y Y Y Y
Engine Oil Level Y Y Y Y
Fuel Level Y Y Y Y
External Tank Fuel Level Y Y Y Y
Others Air Damper Closed Y Y Y Y Y
Battery Charging System Voltage Y Y Y Y
Battery Charger Failure Y Y Y Y Y
Custom Event (see note below) Y Y Y Y Y
Emrg Stop Switch Y Y Y Y Y(1)
Fuel Leak Y Y Y Y Y
In Man Chrg Comb Y Y Y Y Y
(1) This status is FMI 14 (Special Instruction), not FMI 31 (Condition Exists).Note: For custom events, each input can only trigger the custom event number that matches the digital input number. Digital input #1 can only activate custom event #1, and so on.Configuring Digital Inputs for SCADA Datalink
Illustration 60 g02265613
Double click the "Digital Input #N Usage Type" to change this value to "Data Link" from the drop-down menu. Click the"OK" button to program. Disabling Digital Inputs
Illustration 61 g02265673
Double click the "Digital Input #N Usage Type" to change this value to "Disabled" from the drop-down menu. Click the "OK" button to program.