ALTERNATOR GP 4883476 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
The three piece 4T-2911 Cutting Edges bolted to the bucket may bend and/or crack on the machines listed above. The cutting edge may interfere with the weld profile on the bucket base and induces stress when torque applied to the bolts/nuts.Solution
Caterpillar is aware of this problem and recommends following the below interim repair action.In the event of failure, replace the damaged three piece 4T-2911 Cutting Edge with the new single piece cutting edge.