ALTERNATOR GP 5275355 - Caterpillar

Caterpillar Monitoring System
Switch Operations
There are three different switches to the Caterpillar Monitoring System. The switches are the "MODE 0" switch, the "MODE SCROLL" switch, and the "INCREMENT CLEAR" switch. The "MODE 0" switch is used in order to increment through the different parameters of "MODE 0". The "MODE SCROLL" switch is used to increment between Modes 0 to Modes 7. The "INCREMENT CLEAR" switch is used to increment between the different parameters, fault codes, and calibrations. Clear the faults or store the calibrations in modes 1-7.
Illustration 1 g00923811
(1) Mode scroll switch (2) Clear switch
Illustration 2 g01093286
39-11 Left Station Propel Lever
39-12 Left Station Steering Wheel Left/Right Spring
39-13 Right Station Propel Lever
39-14 Right Station Steering Wheel Left/Right Spring
39-21 Left Material Height Paddle Sensor
39-22 Right Material Height Paddle Sensor
39-31 Left Auger Current
39-32 Right Auger Current
39-33 Left Conveyor Current
39-34 Right Conveyor Current
39-41 EDC Forward Current
39-42 EDC Reverse Current
39-51 Tamper Bar Initial, Medium, and Maximum Currents
39-61 Steering Sensor CenterCaterpillar Electronic Technician
Illustration 3 g00952995
Typical example of a calibrate selection screen(This screen is not displayed in the AP-1000D)Use the ET in order to calibrate. Select Service from the main menu. Then, select "CALIBRATION" from the drop-down menu. Select the appropriate calibration procedure from the drop-down menu. Follow the instructions that are provided. See the appropriate Troubleshooting section for your specific calibration procedure.
"Left Station Steering Wheel Left/Right Spring"
"Right Station Propel Lever"
"Right Station Steering Wheel Left/Right Spring"
"Left Material Height Paddle Sensor"
"Right Material Height Paddle Sensor"
"Left Auger Current"
"Right Auger Current"
"Left Conveyor Current"
"Right Conveyor Current"
"EDC Forward Current"
"EDC Reverse Current"
"Tamper Bar Initial, Medium and Maximum Currents"
"Left Station Propel Lever"
"Engine Cooling Fan Maximum/Minimum Speed"
"Steering Sensor Center"