ALTERNATOR GP 5275356 - Caterpillar

Left Station Propel Lever Calibration Using Caterpillar Monitoring System
Note: To access the following procedure after finishing a previous calibration procedure, hold the clear switch UP until "39-41" appears in the display then proceed directly to Step 5.
Get into calibration mode (hold the MODE switch UP until the monitoring system displays "-- 6 --").
After releasing the switch, "39" should appear on the monitoring system display.
Hold the clear switch DOWN until "39-11" appears on the monitoring system display.
Hold the clear switch DOWN until "11-01" appears on the monitoring system display.Note: If conditions are met the control will automaticall step to "11-02".
Activate the left station
Set the engine speed to zero
Hold the clear switch DOWN until "11-02" appears on the monitoring system display.
Place left station propel lever in the NEUTRAL position.
Hold the clear switch DOWN until "11--" appears on the monitoring system display. Calibration is complete.
Table 1
Machine Status    Error Code    Monitor Response    
Engine RPM > 0     NONE     Goes back to Step 1