ALTERNATOR GP 5613002 - Caterpillar

Know the maximum height and the maximum reach of your machine. Serious injury or death by electrocution can occur if the machine or the work tools are not kept a safe distance from electrical power lines. Keep a distance of at least 3000 mm (118 inch) plus an additional 10 mm (0.4 inch) for each 1000 volts over 50000 volts.
For safety, one of the following may require a greater distance:
Local codes
State codes
Requirements of the job site
When swinging into a ditch, do not use the ditch to stop the swinging motion. Inspect the machine for damage if the boom is swung into a bank or an object.Repeated stopping by an object can cause structural damage if the boom is swung into a bank or an object.With certain boom-stick-bucket combinations, the bucket can hit the cab or front of the machine. Always check for interference when first operating a new work tool.Whenever the tracks of the machine raise off the ground while digging, lower the machine back to the ground smoothly. DO NOT DROP OR CATCH IT WITH THE HYDRAULICS. Damage to the machine can result.
With certain combinations of work tools, the work tool pedal can have different functions. Always check the function of the work tool pedal before you use the work tool pedal.Know the location of any buried cables. Mark the locations clearly before you dig.Consult your Caterpillar dealer for special bucket tips that are available for use in severe applications.Move the machine whenever the position for digging is not efficient. The machine can be moved forward or backward during the operating cycle.When you operate the machine in close places, utilize the bucket or other work tools in order to perform the following functions:
Pushing the machine
Pulling the machine
Lifting the tracksUse a comfortable travel speed while you operate the machine.Operating efficiency can be increased by using more than one machine control to perform a task.Never swing a load over a truck cab or workers.Position the truck so that material can be loaded from the rear of the truck or from the side of the truck. Load the truck evenly so that the rear axles are not overloaded.An oversize bucket or a bucket that is equipped with blade type side cutters should not be used in rocky material. These types of buckets slow down the cycle. Damage to the bucket and to other machine components could result.Restricted Operation
Illustration 1 g00818695
Do not use the swing force to perform the following operations:
Soil compaction
Ground breaking
DemolitionDo not swing the machine while the bucket tips are in the soil.These operations will damage the boom, the stick and the bucket and the operations