ALTERNATOR G 5N4875 - Caterpillar

(19) Transmission And Rear Axle Housing
1. Observe oil level at filler opening at rear of axle housing. 2. Maintain oil level to top of filler neck.(20) Brake Cylinder
1. Remove cover located at right of base of power control box.2. Remove filler plug in top of reservoir housing. Clean plug. 3. Maintain fluid level 1/2 inch below filler opening. Install filler plug and cover.(21) Rear Axle Bracket Caps
Lubricate 1 fitting in cap on each side. Total 2 fittings.(22) Pedal Bearings, Power Control Drive Shaft And Engine Mount
Lubricate 4 fittings located below operator's compartment.(23) High-Low Lever
Lubricate 1 fitting at lower end of lever.(24) Gear Selector Rod
Lubricate 5 fittings, one fitting each in gear rod pivot, yoke, front socket, cross shaft bearing and rear socket bearing.(25) Governor Linkage
Lubricate 3 fittings.Lubricate 1 fitting in block below operator's compartment, at right side. Lubricate 1 fitting in each of 2 blocks at rear of engine, one on each side.(26) Fan Bearing
Lubricate 1 fitting until grease appears at relief valve.(27) Alternator And Fan Drive Belts
1. Inspect condition and adjustment of fan and alternator belts.2. Belts should deflect 7/8 inch (22 mm) under 25 lbs (11.5 kg) force. Initial installation new belts-3/4 inch (19 mm).To Adjust Belts
Loosen mounting bolts and move alternator in or out as required. Tighten bolts.