ALTERNATOR G- 5N9026 - Caterpillar

When Required
Engine Air Inlet System - Service filters Ether Starting Aid (If Equipped) - Replace cylinder Fuel System - Change upper secondary fuel filter Fuses and Circuit Breakers - Replace/reset Windshield Wipers and Washer (If Equipped) - Inspect/Fill reservoir Cutting Edge and End Bits - Replace if damaged Ripper Teeth (If Equipped) - Replace if damaged Scarifier Teeth (If Equipped) - Replace if damaged Moldboard Wear Strip (If Equipped) - Replace if damaged Circle Drive Housing - Check oil level Drawbar Ball and Socket - Check/Adjust Blade Circle - Check/Adjust Blade Lift Cylinder Sockets - Adjust/Replace Centershift Cylinder Sockets - Adjust/Replace Filter Inspection - Inspect used oil filter for debris Engine Thermostat - Replace Cooling System Coolant - ReplaceEvery 10 Service Hours or Daily
Engine Crankcase Oil - Check oil level Radiator - Check coolant level Hydraulic Tank Oil - Check oil level Circle Pinion Teeth - Lubricate Circle Top - Lubricate Walk-Around Inspection - Inspect machine Air Reservoir - Drain moisture and sediment Fuel Tank - Drain moisture and sediment Water Separator - Drain moisture and sediment Seat Belt - Inspect Brakes, Indicators and Gauges - Test Backup Alarm - TestEvery 50 Service Hours or Weekly*
Axle Oscillating Bearing - Lubricate fitting Leaning Wheel Bearings - Lubricate fittings Leaning Bar Bearings - Lubricate fittings Leaning Wheel Cylinder Bearings - Lubricate fittings King Pin Bearings - Lubricate fittings Articulation Bearings - Lubricate fittings Drawbar Draft Ball - Lubricate fittings Ripper (If Equipped) - Lubricate fittings Scarifier (If Equipped) - Lubricate fittings Tires - Check inflation pressureEvery 250 Service Hours or Monthly*
Engine Oil and Filter - Change. If the sulfur content in the fuel is greater than 1.5% by weight, use an oil with a TBN of 30 and reduce the oil change interval by one half. When operating the machine at an altitude of 1830 m (6000 ft) and above, shortern the engine oil and filter change interval to 200 service hours or less Cooling System - Add coolant additive Centershift Cylinder - Lubricate fittings Blade Lift Cylinder - Lubricate fittings Transmission and Differential Housing - Check Tandem Drive Housings - Check Fuel System - Change filters Brakes - Test Fan and Alternator Belts - Inspect/adjust Batteries - InspectEvery 500 Service Hours or 3 Months*
Transmission and Differential Oil Filter and Screens - Change/Clean Hydraulic System - Change filter Fuel System - Change filter/clean screen Fuel Tank Cap and Fill Screen - Clean Engine Crankcase Breather - Clean Hydraulic Pump Driveshaft - Lubricate fitting Front Wheel Spindle Bearings - Check oil levelEvery 1000 Service Hours or 6 Months*
Transmission and Differential Oil - Change oil and breather Rollover Protective Structure (ROPS) (If Equipped) - InspectEvery 2000 Service Hours or 1 Year*
Hydraulic System Oil - Change oil Tandem Drive Housing Oil - Change oil Circle Drive Housing - Change oil Engine Valve Lash and Injector Fuel Timing - Adjust Engine Governor - Clean/replace oil supply screen Engine Thermostat - ReplaceEvery 3000 Service Hours or 2 Years*
Cooling System Coolant - Change*First Perform Previous Service