ALTERNATOR G 5R3542 - Caterpillar

If the machine is articulated, the tire sidewalls may be forced against the back slope, causing tire sidewall damage and also forcing dirt between the tire and rim, causing air loss and flat tires.
Personal injury could result from the sudden movement of the blade when the centershift lockpin is released.Before you release the centershift lockpin, make sure that all personnel are clear of the blade. Also, make sure that the circle and the blade are centered under the machine. Position the frame straight and lower the blade to the ground.
Position the link bar so that the centershift lock pin is located at the center hole. Move the switch for the centershift lock to the ENGAGED position.
Illustration 1 g00123505
Set the blade so that the left end is lined up with the outer edge of the left front tire. Tilt the moldboard so that the top of the blade is slightly ahead of the cutting edge.
Lift the right side of the blade to the highest position. Angle the blade in order to deliver the material inside the right rear wheels.
Illustration 2 g00123506
Lower the left side of the blade tip to the desired cutting depth.
Illustration 3 g00189318
Lean the wheels to the right. Make a shallow pass of 50 to 100 mm (2 to 4 inches).
Illustration 4 g00123508
Keep the left front tire in the bottom of the ditch. Continue ditching until you achieve the desired depth of the ditch.