ANCHOR-BRAKE 5T6381 - Caterpillar

Red Mode Indicator
Illustration 3 g03705232
Red mode indicator
When a Remote Shutdown is commanded or a Software Stop is active, the Red indicator lamp flashes twice per second and the RC Status (Blue) indicator lamp is solid.The red indicator lamp is used either when:
Avoidance Stop active (with avoidance installed)
Level 3 Event or Diagnostics
A Remote Shutdown is commanded
A Software Stop is active
An A-Stop is activeThe RC Stop Mode Indicator lights (Red) connect to contact 7 of the RCM, connector J2.Note: Regardless of the machines position in relation to an avoidance zone, the remote control active light will be blinking blue at a rate of two times per second, when in Remote Control mode.Green Mode Indicator
Illustration 4 g03705233
Green mode indicator
When the Manual/Remote Mode switch on the ground level service center (GLSC) is placed in the manual position or the system is placed into Manual override, the green indicators will turn solid green. The green indicators illuminated solid green signifies that the RC System is disabled.Blue Mode Indicator
Illustration 5 g03705229
Blue mode indicator
The Blue System Status indicator lights connect to contact 6 of the RCM, J2 connector. The blue indicators are used to provide remote control status. When the Manual/Remote Mode switch on the ground level service center (GLSC) is placed in the remote position, the blue indicators will turn solid blue. The blue indicators illuminated solid blue signifies that the RC System is enabled (but not active). Once the Operator Console has established communication with the onboard control, the indicator will blink every 2 seconds. This blink signifies the RC System is active. If this indicator is OFF, the RC System is disabled (either by Manual/Remote Mode switch on the GLSC , by the Manual Override switch in cab, or master disconnect is off.)Manual Override Switch
Illustration 6 g03704601
Manual override switch
The Manual Override switch (1) is used to place the machine into manual mode and overrides the remote control system. The Manual Override switch is a momentary switch with the default position being the REMOTE MODE position. To place the machine back into remote control mode once the manual override mode is entered, the user must cycle the Manual / Remote Mode switch on the Ground Level Service Center.Note: When the Manual Override switch, manual position has been pressed, the remote control RCM remains powered. The Manual Override switch is identified with a red rectangle surrounding the switch. The red identification makes the switch more easily seen when needed.The switch is a two-position momentary rocker switch. The switch has ten contacts. When the switch MANUAL (momentary) position is pressed, contact 2 and contact 3 are connected, and contact 5 and contact 6 are connected. When the switch is in the Remote position contact 2 and contact 1 are connected, and contact 5 and contact 4 are connected. Contact 7 and contact 9 are used to control the manual LED in the Switch. Contact 10 and Contact 8 are used to control the Remote LED in the switch. The LEDs are built in voltage indicators. If Manual LED is