ANGLE 2429418 - Caterpillar

Start By:
Remove the tilt cylinder. Refer to Disassembly and Assembly, "Tilt Cylinder - Remove and Install".
Remove the bucket. Refer to Disassembly and Assembly, "Bucket - Remove and Install".
Illustration 1 g01247933
Place suitable cribbing under the front of lift arms (1) .
Illustration 2 g01247934
Attach a suitable lifting device to the rod end of lift cylinder (4). The weight of lift cylinder (4) is approximately 68 kg (150 lb). Use Tooling (A) in order to remove retaining ring (2). Remove pin assembly (3). Use the suitable lifting device in order to lower the rod end of lift cylinder (4) away from lift arms (1). Repeat for the other side.
Illustration 3 g01624895
Disconnect hose assemblies (5) and (6) from each side of the machine. Cut all cable straps (7) that secure harness assembly (8) for the bucket positioner. Place harness assembly (8) to the side.
Illustration 4 g01624898
Attach Tooling (C), Tooling (D), and a suitable lifting device to lift arms (1). The weight of lift arms (1) is approximately 408 kg (900 lb).
Illustration 5 g01247938
Illustration 6 g01624901
Use Tooling (B) in order to remove retaining ring (9). Remove pin (10). Remove lift arms (1) .
Illustration 7 g01248263
Illustration 8 g01248018
Use Tooling (E) in order to remove bearings (11) .
Illustration 9 g01248265
Illustration 10 g01248029
Use Tooling (F) in order to remove bearings (12) .
Illustration 11 g01248315
Remove bearings (13) .