ANGLE 3156853 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-5599 Anti-Seize Compound 1
B - Loctite 242 1
Illustration 1 g02477404
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install shaft (17), roll pin (18), and snap ring (16) to mounting block assembly (15).
Illustration 2 g02477431
Install plate (13) and bolts (14) to the mounting block assembly. Apply Tooling (A) to shaft (17). Note: Note the orientation of the hole patterns in relation to the woodruff key.
Illustration 3 g02477398
Install spacer (12) and snap ring (11). Apply Tooling (A) to spacer (12).
Illustration 4 g02477375
Install spring (10) and woodruff key (9).
Illustration 5 g02477339
Twist spring (8) and install torque arm (7). Apply Tooling (A) to torque arm (7).
Illustration 6 g02477338
Install tubes (5), plate (6), the washers, and bolts (4). Note: Bolts (4) should not protrude beyond plate (6).
Illustration 7 g02476631
Install O-ring seal (3) to position sensor (1).
Illustration 8 g02477319
Apply Tooling (B) to bolts (2). Install position sensor (1) and bolts (2). Tighten bolts (2) to a torque of 1.0 .25 N m (9 2 lb in). Note: Position sensor (1) should be adjusted so that the mark on the sensor dial is aligned with the mark on the housing.End By:
Install the steering control. Refer to Disassembly and Assembly, "Steering Control - Install".