ANGLE AS 9V9890 - Caterpillar

5. Move the governor control lever to the LOW IDLE position.6. Turn the engine key start switch to the START position.7. Release the key switch after the engine starts.Below 0°C (32°F)
Inject starting aid (ether), ONLY while cranking the engine to avoid engine damage.Use sparingly, excessive ether without cranking can cause piston and ring damage.Wait approximately two seconds before injecting again.Use ether for cold starting purposes only.After every 30 seconds of engine cranking, allow 2 minutes for starting motor to cool before cranking again.
1. Repeat steps 1 thru 5 in "Above 0°C (32°F)." 2. Turn the engine key start switch to the START position. After the engine begins cranking, push the ether starting aid switch. Push the switch about every two seconds while cranking the engine.3. Release the key switch when the engine starts. Continue use of the starting aid if necessary until engine runs smoothly. Ether start container is located in the engine compartment. See "Ether Start Aid" in the "Maintenance Section" for container information.For starting below -18°C (0°F), use of optional cold weather starting aids is recommended. A coolant heater, fuel heater, jacket water heater or extra battery capacity may be required.At temperature below -18°C (0°F), consult your Caterpillar dealer, or refer to the "Cold Weather Recommendations, Operation and Maintenance Guide." Form SEBU5898, available from your Caterpillar dealer.Starting With Jumper Cables
Batteries give off flammable fumes that can explode.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow jump cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump cables.Improper jump procedures can cause an explosion resulting in personal injury.Always connect battery positive (+) to battery positive (+) and battery negative (-) to battery negative (-).Jump only with a battery source and with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the jump source is connected.
When starting from another machine, make sure the machines do not touch. This will prevent damage to engine bearings and electrical circuits.Turn OFF (open) the starter switch prior to the boost connection to prevent damage to electrical components on the stalled machine.
Machines with Auxiliary Start Receptacles
Some Caterpillar products may be equipped with auxiliary start receptacles as standard. All other machines can be equipped with a parts service receptacle. A permanent receptacle is then always available for jump starting.Two mating cable assemblies are also available to jump the stalled machine from another machine also equipped with this receptacle or an auxiliary power pack. Your Caterpillar dealer can provide the correct cables in lengths for your application.1. Make initial determination as to failure of the stalled machine to crank. Refer to special instruction SEHS7768 on use of 6V2150 Starting/Charging Analyzer Group. Procedure applies even if machine does not have diagnostic connector. 2. Lower the implements to the ground. Move