ARM AS-LIFTER 1468147 - Caterpillar

Installation Procedure
Side Mounted Turbocharger
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-3931     Anti-Seize Compound     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01363671
Install the turbocharger gasket on exhaust manifold (21) . Apply Tooling (A) to the threads of the taperlock studs.
Attach a suitable lifting device to turbocharger (14) . The weight of turbocharger (14) is approximately 28 kg (62 lb).Note: Discard the locknuts after use. Use new locknuts for installation.
Install turbocharger (14) on the exhaust manifold. Install locknuts (22) .
Install the O-ring seal on tube assembly (20) . Install the tube assembly on the cylinder block. Install bolts (17) .
Install the O-ring seals on tube assembly (18) . Install the tube assembly in the cylinder block. Install bolts (19) .
Illustration 2 g01363669
Install hose (16) on turbocharger (14) . Tighten hose clamp (15) .
Install hose (12) on turbocharger (14) . Tighten hose clamp (13) .
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Coolant System Coolant - Change".Rear Mounted Turbocharger
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-3931     Anti-Seize Compound     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01363684
Install the turbocharger gasket on exhaust manifold (9) . Apply Tooling (A) to the threads of the taperlock studs.Note: Discard the locknuts after use. Use new locknuts for installation.
Attach a suitable lifting device to turbocharger (1) . The weight of turbocharger (1) is approximately 28 kg (62 lb). Install the turbocharger on the exhaust manifold. Install locknuts (8) .
Install hose (11) on turbocharger (1) . Tighten hose clamp (10) .
Install hose (7) on turbocharger (1) . Tighten hose clamp (6) .
Illustration 4 g01053030
Install the O-ring seals on tube assembly (4) . Install the tube assembly in the cylinder block. Position the tube assembly on turbocharger (1) and install bolts (3) .
Install the O-ring seal on tube assembly (5) . Install the tube assembly on the cylinder block. Position the tube assembly on turbocharger (1) and install bolts (2) .
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Coolant System Coolant - Change".End By:
Install the air lines. Refer to Disassembly and Assembly, "Air Lines - Remove and Install".
Install the exhaust elbow. Refer to Disassembly and Assembly, "Exhaust Elbow - Remove and Install".