ARM GP-PUSH 1U2446 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 185-3630 Strap Wrench Assembly 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01167050
Illustration 2 g01270505
Use Tooling (A) to remove fuel filter (2).
Disconnect hose assemblies (4) and (5) from fuel filter base (1). Immediately cap all openings or plug all openings in order to prevent contamination.
Disconnect fuel sensor (3) from fuel filter base (1).
Remove bolts (6) and the washers from fuel filter base (1). Remove fuel filter base (1) from the bracket. Installation Procedure
Illustration 3 g01270505
Illustration 4 g01270530
Position fuel filter base (1) on the bracket. Install bolts (6) and the washers.
Connect hose assemblies (4) and (5) to fuel filter base (1).
Connect fuel sensor (3) to the fuel filter base.
Install fuel filter (2). Refer to the Operation and Maintenance Manual, "Fuel System Secondary Filter - Replace" topic for more information.
Prime the fuel system. Refer to the Operation and Maintenance Manual, "Fuel System - Prime" topic for more information.