ARM AS 2340729 - Caterpillar

Illustration 1 g00849015
(A) Bucket cylinder. (B) Bucket control linkage. (C) Bucket. (D) Stick cylinder. (E) Boom.Note: All bores must be free of paint. Coat all bores for pins with lubricant. (1) Lubricate the sealing lip slightly with the lubricant that is being sealed. (2) Two 192-8261 Sleeve Bearings Outside diameter ... 140.198 0.011 mm (5.5196 0.0004 inch) Inside diameter ... 120.320 0.020 mm (4.7370 0.0008 inch) Install the bearing in the bearing bore. ... 9.5 0.8 mm (.37 .03 inch) (3) 5I-3299 Pin Assembly Diameter after plating ... 79.850 0.025 mm (3.1437 .0010 inch) Minimum thickness for plating ... 0.005 mm (.0002 inch) Bore diameter for pin ... 80.037 0.037 mm (3.1511 .0015 inch) (4) Two 7Y-3551 Sleeve Bearings Outside diameter ... 85.160 0.013 mm (3.3527 .0005 inch) Inside diameter ... 70.23 0.02 mm (2.765 .001 inch) Install the bearing in the bearing bore. ... 7.5 0.8 mm (.30 .03 inch) (5) Torque for two bolts ... 460 60 N m (340 45 lb ft) (6) 166-1487 Shims ... 2.00 0.15 mm (0.079 0.006 inch) (7) 113-2963 Pin Assembly Diameter after plating ... 89.850 0.025 mm (3.5374 .0010 inch) Minimum thickness for plating ... 0.005 mm (.0002 inch) Bore diameter for pin ... 90.043 0.043 mm (3.5450 .0017 inch) (8) Two 208-1959 Sleeve Bearings Outside diameter ... 106.200 0.013 mm (4.1811 .0005 inch) Inside diameter ... 90.27 0.02 mm (3.554 .001 inch) Install the bearing in the bearing bore. ... 9.5 0.8 mm (.37 .03 inch)