ARM AS-WIPER 2602579 - Caterpillar

Illustration 1 g00512021
(1) Transmission lubrication hydraulic filter
(2) Pulled unit brake cooling hydraulic filter
(3) Torque converter, pulled unit, brake, and transmission hydraulic tank Pulled unit brake cooling hydraulic filter (2) is fastened to the right side of the main frame in front of the torque converter, pulled unit, brake, and transmission hydraulic tank (3) and behind the transmission lubrication hydraulic filter (1).
Illustration 2 g00331996
Components of pulled unit brake cooling hydraulic filter
(4) Bypass valve
(5) Spring
(6) Outlet passage
(7) Base
(8) Inlet passage
(9) Element
(10) Housing Oil from the hydraulic tank flows to the pulled unit and rear brake cooling gear pump. The rear section of the pump sends oil to the pulled unit brake cooling hydraulic filter.Oil flows through inlet passage (8). The oil fills the space between the inside of housing (10) and element (9). During normal operation, the oil flows through element (9) and out outlet passage (6) to the remainder of the hydraulic system. Element (9) stops any debris that is in the oil.If filter element (9) becomes full of debris, the restriction to the flow of oil causes a pressure increase inside the filter. The pressure oil causes bypass valve (4) to move against the force of spring (5). Also, the bypass switch (2) will be activated and an alarm will be registered in the cab.The oil then flows past the open bypass valve and to the remainder of the hydraulic system. When the oil does not flow through the filter element, the debris in the oil will cause damage to other components in the hydraulic system.Use correct maintenance in order to make sure that element (9) does not become full of debris. If element (9) is full of debris, the flow of clean oil to the hydraulic system is stopped.