ARM AS 2G8814 - Caterpillar

Implement Software Changes
First Production flash file for 950M and 962M
Upgraded Caterpillar Production Measurement feature
Modified default Battery Cable Shield Monitor to "Enable" state
Resolved erroneous fuel level reporting when key switch is OFF
Configured Implement Swash Plate Angle sensor fault codes to WCI level 2
Modified Implement torque limits status parameters to Active state
Updated kickout and snubbing maps for 966M and 972M machines
Addressed the latching conditions for diagnostic codes 800-9 and 248-9
Configured the WCI to level 2 for the Implement Pump Pressure sensor diagnosticTransmission Software Changes
First Production flash file for 950M and 962M machines
Updated Steering System to reduce activations of the secondary steering pump
Updated Steering System performance tuning values
Enhanced logic for Event 284: Low Brake Accumulator Pressure: WCI 3
Added Event 1560: Low Brake Accumulator Pressure Due to Low Engine Speed
Enhance logic for Transmission Fill Calibration
Enhanced logic for Wheel Speed Sensor Diagnostic detection: CID 605-2 and CID 608-2
Enhanced In Gear Slip Detection logic to prevent unnecessary detection
Removed ability to change lock down shift tables on 980M
Removed condition to Keep ECM Alive During DES
Consolidated total hours, total distance, and total number of occurrences to one cohesive unit
Enhanced torque converter and transmission speed sensing during "Active" mode
Enhanced cold mode start / crank
Enhanced implementation of the cylinder arbitration block
Enhanced Backup Alarm functionality
Improved autoshift points when Economy Mode is active for 966M and 972MRelay Driver Module Software Changes
Added compatibility with new HVAC and Wiper Dial inputs. This software remains backwards compatible.Display Module Software Improvements
Info pop-up updates for DES, DEF Purge, and Lockup Clutch Engaged
New Info Display hardware now programs itself with the machine serial number
3rd and 4th function value flow settings now able to be set down to 20%
Selectable Quad feature
Caterpillar Production Measurement support with Network Manager and Legacy VIMSPL 522 Software Changes
Note: Enter the part number of the files, when searching for the software and configuration files in SIS Web. Entering the machines Serial Number will not always give the compatible configuration file for the flash file used on the VIMS / Product Link platform.
Enhanced support for the currently selected Material ID information to be available along with the Truck ID information, on certain MWL machines equipped with Cat Production Measurement
Implemented resolution for potential ECM resets that could result in generating incorrect or missing printer ticket information on certain MWL machines equipped with Cat Production Measurement or Payload Control System
Enhanced the ability to change units of measurement between English and Metric, on certain MWL machines equipped with Payload Control SystemAdaptable To: The new software part numbers are listed in Table 1.
Table 1
New Software    
Qty    New Part Number    Description    Part Name    Former Part Number    
1     463-1175     Monitor