ARM A 2H9366 - Caterpillar

Remove tube assembly (1).
Illustration 2 g01264821
Install 261-4518 Tube As (3) with the existing bolts (2) .
Illustration 3 g01264823
Remove the paint from 261-4518 Tube As (3). Install the 250-2972 Strainer onto the threads of 261-4518 Tube As until resistance is felt. The strainer must be tightened one complete turn after resistance is felt.
Illustration 4 g01264944
Install the hose and clamps (4). Install 261-4520 Tube As (5), one 095-1724 O-Ring Seal , eight 8T-4121 Hard Washers and eight 8T-4195 Bolts .
Illustration 5 g01264982
Remove tube assembly (6) .
Illustration 6 g01265024
Install 266-7169 Tube As (7) to the saw pump. Install one 4J-0527 O-Ring Seal , four 8T-4223 Hard Washers , and four 8T-8919 Bolts .
Illustration 7 g01265079
Install 266-7157 Tube As onto 266-7169 Tube As (7). Install one 7X-1547 O-Ring Seal , eight 8T-4224 Hard Washers , and eight 8T-7547 Bolts .
Install 9S-4182 Plug (9) and 3J-7354 O-Ring Seal onto 266-7157 Tube As .
Install 250-2972 Strainer (10) onto 266-7169 Tube As (7). The strainer must be tightened one complete turn after resistance is felt.
Illustration 8 g01265176
Weld 9C-7929 Block (11) to the engine mount.
Install 266-7157 Tube As (8) on 276-7397 Bracket with two 8T-8919 Bolts (12) and two 8T-4223 Hard Washers .
Illustration 9 g01265226
Install the existing 211-1080 Hose (13) and the 144-0367 Hose Clamps onto 266-7161 Tube (14) .
Install 7X-7893 Hose (15) and two 8T-4985 Hose Clamps onto 266-7161 Tube .
Illustration 10 g01265365
Install 266-7161 Tube onto the filter housing and onto the filter housing.
Fill the hydraulic system with hydraulic oil. The capacity of the hydraulic system is approximately 300 L (79 US gal). Slowly loosen the air vent plugs on the filter housing. Oil will flow out of the opening in the plugs when the air in the pumps and the air in the filter housings has been purged.
Tighten the plugs.