ARM GP-LIFT 3214060 - Caterpillar

Disconnect harness assembly (12). Disconnect ground strap (13) .
Illustration 9 g00908521
Disconnect harness assembly (14). Remove clip (15) .
Illustration 10 g00908529
Unplug harness assembly (16) from the horn.
Illustration 11 g00908537
Remove compartment (17) by pulling straight up.
Illustration 12 g00909032
Remove vents (18) .
Illustration 13 g00908551
Remove bolts (19). Remove duct assembly (20) .
Illustration 14 g00908565
Remove bolt (21). Remove duct assembly (22) .
Illustration 15 g00908598
Drain the coolant from the cooling system into a suitable container for storage or disposal. The capacity of the cooling system is approximately 15 L (4 US gal). Refer to Operation and Maintenance Manual, SEBU7613, "Cooling System Coolant (DEAC) - Change" or refer to Operation and Maintenance Manual, "Cooling System Extended Life Coolant - Change".
Disconnect heater hoses (23). The heater hoses are located under the seat.
Illustration 16 g00908730
Remove bolt (24). Disconnect harness assembly (25) .
Illustration 17 g00908741
Loosen nuts (26) that secure governor control cable (29) to the bracket. Remove nut (27). Remove the governor control cable from the lever assembly. Remove clips (28). Position the governor control cable under the engine.
Illustration 18 g00908971
Attach Tooling (B) to the cab. Use a suitable lifting device. The weight of the cab is approximately 265 kg (584 lb).
Illustration 19 g00908977
Remove front two cab mounting bolts (30) .
Illustration 20 g00908981
Remove the left rear cab mounting bolt (31) .
Illustration 21 g00908985
Remove the right rear cab mounting bolt (32) .
Illustration 22 g00916337
Remove cab (33) from the machine.
Raise the cab slowly. Check for additional lines or connections that could be damaged.