ARM-BAIL 3535193 - Caterpillar

Illustration 7 g01445507
(46) Parking Brake Lever (47) Parking Brake Release (48) MP Bucket Control (if equipped) (49) Loader Joystick (50) Transmission Neutralizer SwitchThe joystick for the loader (49) uses a mechanically controlled loader valve. Located on the front of the joystick is the transmission neutralizer switch (50). The parking brake release lever (47) is located at the front of the parking brake lever.
Illustration 8 g01445519
Backhoe Controls (Pilot Controlled Valve configuration) (51) Backhoe Joysticks (52) Boom Lock Lever (53) Pilot Control Pod LeverThe backhoe joysticks (51) with a pilot controlled backhoe valve are shown. The left pilot joystick is equipped with thumb switches to control the auxiliary functions (if equipped) and a horn switch. The right joystick is equipped with a thumb switch to control the Extendable-Stick (if equipped) or a hammer (if installed). The boom lock lever (52) locks the boom in place for machine travel. The pilot control pod lever (53) allows adjustment of the pilot lever pods.
Illustration 9 g01445520
Backhoe Controls (Mechanical Controlled Valve configuration) (54) Backhoe LeversThe 450E machine with a Mechanical Control backhoe will have a four-lever control configuration. A two-lever mechanically controlled configuration of the backhoe joysticks (54) is shown.
Table 1
"Excavator" Pattern    
Left Joystick    Right Joystick    
Forward: Stick Out     Forward: Boom Lower    
Rearward: Stick In     Rearward: Boom Raise    
Right: Swing Right     Right: Bucket Dump    
Left: Swing Left     Left: Bucket Close    
Table 2
"Backhoe" Pattern    
Left Joystick    Right Joystick    
Forward: Boom Lower     Forward: Stick In    
Rearward: Boom Raise     Rearward: Stick Out    
Right: Swing Right     Right: Bucket Dump    
Left: Swing Left     Left: Bucket Close    
Illustration 10 g01445525
Left Console (55) Joystick Pattern Switch (56) Storage CompartmentThe default pattern for the joystick is the "excavator" pattern. The alternate pattern for the joystick is the "backhoe" pattern. The pattern for the joystick is selected using the joystick pattern switch (55) which is located to the right of the operator seat. A storage compartment (56) is also located next to the pattern switch for the joystick.
Illustration 11 g01445526
(55) Joystick Pattern Switch (57) Joystick Pattern DecalThe switch for the joystick pattern (55) controls two solenoids that allow the backhoe controls to change from an "excavator" to a "backhoe" control pattern. Press the top of the switch in order to select the "excavator" pattern. Press the bottom of the switch in order to select the "backhoe" pattern.Note: A decal (57) illustrates the joystick pattern options.
Illustration 12 g01445536
(58) 12 V Power Port (Right Side) (59) Cat ET Connector (60) Fuse PanelLocated inside the right door is the Cat Electronic Technician (ET) connector (59) and the fuse panel (60). The cover to the fuse panel has been removed in Illustration 12.
Illustration 13 g01445540
(61) 12-Volt Power Port (Left Side)Located inside the door on each side of the machine are two 12-volt power ports (58) (61).
Illustration 14 g01445558
(59) ET Connector (60) Fuse Panel (62) Fuse Panel Cover (63) DecalThe fuse panel (60) is shown with the cover (62) removed. The fuse panel includes