ARM & BEARING AS-LIFT 3593074 - Caterpillar

Illustration 1. This drawing shows the difference between how the rays of light change direction on the new tape surface in comparison with normal surfaces.The new tape can be used on shafts, gears, fan blades, etc. You must always put the tape in a location so the light from the photohead hits the tape. One piece of tape is enough, but the more pieces of tape used, the more exact the rpm indications will be.
The tape adheres (holds) strongly to any surface if it is almost clean. A cover, or liner, is used on the tape so it will not stick (fasten) together when in a roll. For this reason, the tape must be used and put in storage carefully so the roll will always be together. One recommendation is to put 4 pieces of any kind of tape on both sides of the roll. See Illustration 2. Keep the roll of tape in the bag the tape came in to protect the tape.
The tape is .5' (13 mm) wide and 50 yards (45.7 m) are in each roll.
Illustration 2. Use pieces of tape to keep the roll together when in storage.