ARM AS 4738441 - Caterpillar

Make D-shape cut out to accept 3D harness using the dimensions provided.
Drill two 8.2 mm (0.32 inch) holes for the harness mounting hardware.Installation Procedure
Illustration 8 g06276637
Overview of harness to be installed on machine. Machine background geometry is transparent, and machine frame is shown as reference for harness routing.
Route harness from right rear storage cabinet to rear side of operator platform.
Illustration 9 g06277665
Start routing harness by installing the rear most harness plug into the rear storage cabinet on the right side using nut (8). Secure the harness to the existing wiring that is tied to the rear machine frame with tie straps (7) as needed.
Illustration 10 g06272727
Continue running the harness next to the existing wire harness as shown along the rear of the machine. Secure the harness to the existing wiring with tie straps (7) as needed.
Illustration 11 g06272754
Route harness around the left rear of machine. Plug connector end on the short harness end into electrical panel on rear left of machine as circled.
Illustration 12 g06272976
Continue routing harness around the left side of the main drive housing and under the drive pulley as shown. Secure the harness to the existing wiring with tie straps (7) as needed.
Illustration 13 g06277844
Route harness toward the operator panel. Secure harness connectors using clip (10) and cable straps (2). Secure the harness to the existing wiring with tie straps (7) as needed.
Illustration 14 g06277852
Continue routing the rest of the harness up to the panel behind the operator station. Install harness connection in panel and secure the harness to the existing wiring with tie straps (7) as needed.
Illustration 15 g06277443
Install bracket (12) using two bolts (4) and two washers (5).
Illustration 16 g06277469
Slide spring clip (9) over harness connector and mount to bracket using four screws (1).
Illustration 17 g06277472
Install dust cap (3).
Illustration 18 g06273086
Continue routing harness to the other panel behind the operator station. Install harness connection in panel and secure the harness to the existing wiring with tie straps (7) as needed.
Illustration 19 g06277480
Install bracket (12) using two bolts (4) and two washers (5).
Illustration 20 g06277489
Slide spring clip (9) over harness connector and mount to bracket using four screws (1).
Illustration 21 g06277609
Install dust cap (3).