ARM & BRG.A. 4K2144 - Caterpillar

Illustration 1 g00885992
(A) Boom cylinder (B) Stick cylinder (C) StickNote: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (1) Two 186-5476 Sleeve Bearings Outside diameter ... 130.135 .012 mm (5.1234 0.0005 inch) Inside diameter ... 110.300 .020 mm (4.3425 0.0008 inch)Note: All bores must be free of paint. Coat all bores for pins with lubricant. (2) 186-5637 Pin Diameter after plating ... 89.850 .025 mm (3.537 0.001 inch)Thickness of plating Layer 1 ... 0.015 mm (0.0006 inch) Layer 2 ... 0.015 mm (0.0006 inch) (3) 4I-4618 Pin As Diameter after plating ... 79.850 .025 mm (3.144 0.001 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) (4) 186-5578 Pin As Diameter after plating ... 99.850 .025 mm (3.931 .001 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) (5) Lubricate the sealing lip slightly with the lubricant that is being sealed. Install the dust seal so that the lip faces to the outside. Refer to the detail. Install the seal so that the seal does not extend beyond the face of the boss. (6) Use shims to adjust the lateral clearance. Mount the steel shim on the boom side. Maximum lateral clearance ... 1.6 mm (0.06 inch) 093-0090 Shim ... 1 mm (0.04 inch) 133-2427 Shim ... 0.5 mm (0.02 inch) Two 166-1488 Shims ... 2.00 .015 mm (0.0787 0.0006 inch)