ARM-PIVOT 5306338 - Caterpillar

Table 1
Required Tools    
Tool     Part No     Description     Qty    
A     6V-7788     Flow Meter Gp (10-76 L/min) (206-20 US gal/min)     1    
8C-6874 Connector     2    
6V-9746 O-Ring Seal     2    
B     122-6882     Hydraulic Hose (1M ) (40 inch)     1    
124-2121 Permanent Coupling (Female Swivel)     2    
C     4C-6500     Digital Thermometer     1    Note: Perform this test if maximum fan speed cannot be achieved.
Drive the machine to a smooth, horizontal surface.
Illustration 1 g02964957
Move propel lever (1) to the NEUTRAL position.
Move parking brake switch (2) to the ON position.
Illustration 2 g02964960
Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle.Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First, "Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
Illustration 3 g02964962
Move engine start switch (4) to the OFF position.
Assemble Tool (A). Assemble Tool (B). Connect Tool (B) to outlet side of Tool (A) .
Illustration 4 g02964963
Disconnect hose assembly (6) from inlet port (5) of charge filter (7) .
Connect hose assembly (6) to the inlet side of flowmeter in Tool (A) .
Connect Tool (B) to inlet port (5) of charge filter (7) .
Illustration 5 g02964966
Unhook latch (8) and open the engine compartment.
Illustration 6 g02964967
Remove locking pin (10). Raise support bar (9). Lock the support bar in position with the locking pin.
Illustration 7 g02964968
Disconnect fan solenoid (11) from the machine harness assembly.
Move engine start switch (4) to the START position. Release the switch when the engine starts.
Operate the engine at low idle for a few minutes. Use throttle control switch (3) in order to operate the engine in high idle.Note: Two things indicate when the engine is at high idle. First, "High Idle" will appear on the display. Second, the third LED next to throttle control switch (3) will be illuminated.
Monitor the hydraulic oil temperature with Tool (C). Operate the machine until the oil temperature reaches 38 °C (100 °F).
Read flow on Tool (A). The flow should be a minimum of 55.5 L/min (14.7 US gpm).
Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle.Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First, "Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
Move engine start switch (4) to the OFF position.
Remove Tool (A). Reconnect hose assembly (6) .Note: If the flow is less than 55.5 L/min (14.7 US gpm),