ARM 5H2566 - Caterpillar

Illustration 2 g03882781
Overview of the 369-5226 Auxiliary Hydraulic Lines Gp
Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, hose assemblies, harness assemblies, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. Plugging hoses and tubes helps to prevent fluid loss, and helps to keep contaminants from entering the system.
Illustration 3 g03882786
Right side of the stick
(1) 262-3233 Tube As
(2) 356-8085 Hose As
(4) 389-2407 Manual Valve Gp
(5) 173-7916 Half Clamp
(6) 1P-3704 Rectangular Seal
(7) 1P-5767 Half Flange
(8) 8C-8992 Locking Bolt
(9) 8T-4121 Hard Washer
(10) 8T-4183 Bolt
(11) 8T-4194 Bolt
(12) 8T-4223 Hard Washer
(13) 8T-6685 Bolt
(14) 7X-0584 Hard Washer
Install the lines group onto the right side of the stick.
Illustration 4 g03882789
Left side of the stick
(1) 262-3233 Tube As
(2) 356-8085 Hose As
(4) 389-2407 Manual Valve Gp
(5) 173-7916 Half Clamp
(6) 1P-3704 Rectangular Seal
(7) 1P-5767 Half Flange
(8) 8C-8992 Locking Bolt
(9) 8T-4121 Hard Washer
(10) 8T-4183 Bolt
(11) 8T-4194 Bolt
(12) 8T-4223 Hard Washer
(13) 8T-6685 Bolt
(14) 7X-0584 Hard Washer
Install the lines group onto the left side of the stick.
Tighten all hardware and fittings to proper torque unless otherwise specified. Refer to Specifications, SENR3130, "Torque Specifications".
Illustration 5 g00687600
Personal injury or death can result from escaping fluid under pressure.Escaping fluid under pressure, even a very small pin-hole size leak, can penetrate body tissue, causing serious injury, and possible death.Always use a board or cardboard when checking for a leak.Do not check for pin hole leaks in pump or motor hoses during a steer stall condition. If fluid is injected into your skin, it must be treated by a doctor familiar with this type of injury immediately.
Inspect the fittings for hydraulic leaks.